The horizontal ribbon mixer is composed of U-shaped container, ribbon stirring blade and transmission parts. The ribbon blade is generally made into two or three layers. The outer spiral gathers the materials from both sides to the center, and the inner spiral gathers the materials. Conveyed from the center to both sides, forming a convective mix. The ribbon mixer has a good effect on the mixing of viscous or cohesive powders and granules, and the addition of liquids and paste materials in the powders and granules. The cylinder cover can be made as a full-open door for cleaning the equipment Replace the product.
Standard products use belt pulleys to drive the cycloid reducer. Compared with the high torque of the gear reducer, the elastic connection of the belt drive has the advantage of protecting the transmission parts during overload.
2. Flexible disassembly
The ribbon spindle is connected to the drive shaft flange in simplified Chinese and can be quickly disassembled when the mixing shaft type needs to be repaired or replaced. The flexible disassembly design makes the U-shaped simplified welding with the two end plates completely, avoiding the accumulation gap caused by the large flange connection and reducing the residue.
Compared with continuous ribbons, disconnected ribbons have a greater shear motion on the material, and can cause the material to form more eddies in the flow, which speeds up the mixing speed and improves the uniformity of mixing. .
4. Output form
Discharging form-~ Pneumatic (manual) flap valve, circular arc valve is tightly embedded in the Jane, flush with Jane's inner wall, no material accumulation and mixed dead angle phenomenon, reliable side seal, guarantees frequent switching No leaks.
5. Cooling and heating
Jackets can be added to the outside of the mixer barrel to cool or heat materials by injecting cold and hot media into the jackets. Cooling-generally pump industrial water, heating can be steam or electric heating oil.
Note: 1. The mixing amount in the table is measured by using the powder with a bulk density of 1 as the medium. The selection should be calculated based on the mesh number of the product, the bulk density of the material, and fluidity.
2. If there are working conditions such as high temperature, high pressure, flammable, explosive, corrosive, viscous, etc., detailed data must be provided in order to select and customize separately. 3. The data and pictures in this table are subject to change without notice.
4. This table does not include all products. For more information, please contact the company's sales engineer.