Sometimes, the difference between our operation method and settings will make the crusher's effect of crushing the articles poor. No matter it is to increase the speed of the extension or set the parameters, it will not achieve good results. The powder will tell you how to improve the crushing effect.
To increase the feeding speed, the principle of airflow crushing is mainly to rely on high-speed airflow to cause a strong collision between the powder and the powder, and the powder and the inner wall to achieve the effect of crushing. If the feed is too small, the purpose of frequent and strong collisions cannot be achieved, so that the strength cannot be reduced. In addition, if the fan damper is too large and the internal negative pressure is too large, the collision will be reduced, otherwise the positive pressure is not good.
If neither of the above two methods can achieve a good crushing effect of the crusher, then it may wish to try cleaning the machine to see how effective it is. It may also be that the dust in the machine affects the efficiency and effect of the work.
The pulverizer is used to pulverize the articles, so the pulverized articles and tailings should also be discharged in time. When the pulverizer discharges these pulverized articles, there will be dust. So if the dust has passed, how to solve it, Jingxin powder machinery wants some methods, I will share with you below.
1. Install dust collector: Generally, this type of dust collector can be used with a pulverizer. It collects dust into a collection bag, and the dust is filtered through a cloth bag and discharged;
2. Dust-proof cloth bag: The cloth bag is tightly connected with the powder outlet of the machine to prevent air leakage. During operation, pay attention to blocking the powder outlet, and clean up the dust in time.
3, wood shower or pool dust removal: mainly use a fan to vacuum outside the crushing room, and then spray to vacuum, or use a pool to vacuum.
The above three methods of dust removal can achieve very good dust removal effects and can solve the problem of excessive dust. Generally, it is best to install these dust removal devices before work to prevent excessive wind and dust.