Regarding the questions on the jet mill , that is, some difficult questions for it, this has always been a place where everyone is confused, and it is also the focus of our study. Because they may be encountered in practice, if they are not solved well, then it will affect the use of air jet mills and other aspects. So below, the jet mill manufacturer Anqiu Jingxin powder processing equipment will come to answer some of them in order to answer questions for everyone.
1. Can the jet mill reach 6250 mesh? For static jet mills, what is the particle size?
For the jet mill, there are still some difficulties in achieving 6250 mesh. Moreover, for ordinary grinders, this requirement cannot be met at all. As for the latter question, the answer of the air jet mill manufacturer HTC is: The static air jet mill has a particle size of D100.
2. On the jet mill, if the temperature of the outlet of the induced draft fan is too high, how can it be solved? What are the main equipments for a complete jet mill system?
For these two questions, the answer given by the jet mill manufacturer HTC is:
The temperature of the outlet of the induced draft fan on the jet mill is high, so it can be installed at the air inlet to solve the problem. For a complete jet mill system, it must be included, which is a jet mill, classifier, fan and dust collector.
3. How should the feed speed and induced air volume of the jet mill be matched?
If we want to achieve a good match between the feed speed of the jet mill and the amount of induced air, then what we can do is to increase the feed speed appropriately. In addition, the fan damper should be controlled so as not to make it too large, so as to prevent the negative pressure inside the crusher from becoming too large, which will affect the crushing effect.
4. What are the specific requirements for the jet mill in the laboratory?
This question is not difficult for Hongda, a manufacturer of jet mills, to answer. Its specific is for:
The basic functions of the crusher should be determined carefully and carefully, mainly to see whether the crushing fineness of the crusher can meet the crushing requirements. And, for the equipment, does it have the advantage of being easy to clean. In addition, in terms of form, it is also necessary to choose an appropriate form according to the actual situation.